I have seen many questions on the Internet about whether the movement of cross-stitch wall clocks can be replaced. As a fan of cross-stitch and a production technician of watch movements, I have also answered many questions about the movement of cross-stitch wall clocks. However, it may be due to time constraints or Questions about permissions on the Q&A platform cannot be fully answered. Today, I made this request on the website of Hengrong clock Company, mainly in the form of an article to explain to you what movements can be replaced in cross-stitch wall clocks and the installation steps of cross-stitch wall clock movements.

What movements can be replaced with cross-stitch wall clocks? Generally, most of them are tick-tap seconds movements and scanning silent movements. If you have better ideas, you can also choose to have a ticking quartz clock movement, which can be used with a chime music box to keep the hour time. You can also install a 24-hour quartz clock movement, a high-torque movement, a radio wave movement, etc., but please note that when purchasing a clock movement, you must explain to the seller that the movement must have a copper threaded shaft, because there are The copper threaded shaft can be fixed on the cross-stitch and makes it easier to replace the clock movement in the future.

In addition, if you install or replace the clock movement by yourself, it is also very simple. First, punch an 8mm hole in the middle of the cross-stitched clock number. It must be in the middle, otherwise the wall clock will not keep accurate time. Then take the movement shaft Pass the 8mm hole you just drilled, and tighten the movement with the movement accessory hexagonal screws and washers. Then you can install the clock hand. Install the clock hand according to the steps of hours, minutes and seconds. Align the hour hand with the 12 clock position and gently rock it. Leave a 4 to 6mm distance between the clock hand and the cross-stitch clock face. Then press the minute hand. The second hand is OK. Remember to keep the distance between the needles. Just reverse the steps to replace the movement, remove the movement and then install it. I hope the above content can help you in need.