In addition, if you install or replace the clock movement by yourself, it is also very simple. First, punch an 8mm hole in the middle of the cross-stitched clock number. It must be in the middle, otherwise the wall clock will not keep accurate time. Then take the movement shaft Pass the 8mm hole you just drilled, and tighten the movement with the movement accessory hexagonal screws and washers. Then you can install the clock hand. Install the clock hand according to the steps of hours, minutes and seconds. Align the hour hand with the 12 clock position and gently rock it. Leave a 4 to 6mm distance between the clock hand and the cross-stitch clock face. Then press the minute hand. The second hand is OK. Remember to keep the distance between the needles. Just reverse the steps to replace the movement, remove the movement and then install it. I hope the above content can help you in need.